Do you still worry about your GB0-371-ENU exam and want to get valid practice questions so that you can master the key knowledge soon? Now we PracticeDump provide you the best GB0-371-ENU exam pdf practice material. Also before purchasing we provide the GB0-371-ENU practice test free for your reference. You can download the practice material free at any time.

As we all know the pass rate of GB0-371-ENU exam is really low, many people have to take exam twice, three times or even more. They spend a lot of money and time on this exam since they do not know about our GB0-371-ENU exam practice material. When they know many people pass exam once by our GB0-371-ENU test engine, they regret it and try to download other subject exams of our GB0-371-ENU practice test free. The practice exam online would help them pass GB0-371-ENU exam at first time and they will consider to purchase practice questions if they take other exams. The GB0-371-ENU is not very difficult with our practice material.

You will also care about our service after you purchase our GB0-371-ENU practice material pdf or practice exam online. Of course we have good customer service so that we can grow up and have good reputation in this area.

Firstly, we are 7*24 online service. No matter when and where you have problems and advice you can contact us, we will try our best to serve for you and reply you ASAP. After purchasing we will provide you one-year service warranty, you can get the latest GB0-371-ENU pdf practice material or practice exam online and contact us at any time.

Secondly, all we sell are the accurate and valid practice material, if you have doubt about GB0-371-ENU practice material pdf or practice exam online please email us. Our IT staff updates information every day. If it is old version we will notice you to wait the update version. We must assure all customers pass exam once by our GB0-371-ENU exam practice material.

Thirdly, we keep your information in secret and safe. After passing exam if you do not want to receive the update version of GB0-371-ENU exam pdf practice material or (Constructing H3C High-Performance Campus Networks) practice exam online please email us we will not send you any junk emails.

For reasons of space I have missed out some of the details. If you have any doubt please email us I will tell you details. In the end I says again 100% pass, No Help Full Refund.

Instant Download: Our system will send you the PracticeDump GB0-371-ENU practice material file you purchase in mailbox in a minute after payment. (If not received within 12 hours, please contact us. Note: don't forget to check your spam.)

H3C Constructing H3C High-Performance Campus Networks Sample Questions:

1. The customer's two switches SWA and SWB are connected by seven Ethernet cables and configured with static link aggregation. The corresponding ports on the switch SWA are Ethernet 1/0, Ethernet 1/0/2, and Ethernet 1/0/3 , Ethernet 1/0/4, Ethernet 1/0/5, Ethernet1/0/6, Ethernet 1/0/7, the configuration method is to configure according to the order of the ports. If the switch SWA, SWB each aggregation group only supports 6 ports ,then

A) When the configuration of each port is the same, SWA randomly selects a port among the 7 ports as the Unselected port of the aggregation group
B) When the configuration of each port is the same, the Ethernet1/0/7 port is the Unselected port of the aggregation group
C) In the case of the same port configuration, Ethernet1/0/6 port is the Unselected port of the aggregation group
D) In the case of the same port configuration, Ethernet1/0/1 port is the Unselected port of the aggregation group

2. In the networking shown in the figure, the interconnection lines between RT1, RT2, RT3, and RT4 are all 1000M links except the shared Ethernet part which is a 10M link. The OSPF protocol is run to enable routing to communicate with these 4 routers. Both run PIMSM protocol, RP is 1.1.1.1, receivers are connected to the downstream interfaces of RT1 and RT2, and IGMP is enabled on the corresponding interfaces. Then, when the receiver sends a group join request, which of the following routers are connected (*, G) entry exists?

A) RT1
B) RT2
C) RT3
D) RT4

3. In the switching network shown in the figure, VLAN10 is set as Isolate-user-vlan on the switch SWA, VLAN2 and VLAN3 are set as the Secondary VLAN of VLAN 10; VLAN2? VLAN20 is created on the switch SWB, and VLAN20 is set as Isolate-user-vlan , VLAN4 is VLAN20 Secondary VLA after setting the IP address of each device as shown in the figure, the local proxy ARP function is enabled on both SWA and SWB. At first, the switch and pc did not learn their corresponding ARP entries in PCA. During the process of pinging PCB, PCA will send an ARP request. The source MAC address of the ARP request packet forwarded by the switch to PCB is

A) 0000.0000.0000
B) 00E0.FC00.0020
C) 00E0.FC00.0010
D) 0011.1111.1111

4. Regarding TC protection, the following statements are correct

A) The system monitors whether the number of TC-BPDU packets received during this time period is greater than the threshold. If it is greater than the threshold, the device will delete the address table entry again after the time expires, so as to avoid frequent deletion and forwarding Address table entry
B) After the switch receives the TC-BPDU message, it will delete the MAC address table entry
C) TC protection is configured in the system view
D) After the TC protection function is enabled, within 10 seconds after receiving the TC-BPDU message, the device allows the number of address table item deletion operations immediately after receiving the TC-BPDU message can be controlled by the user

5. The switches SWA and SWB are connected together through two optical fiber Gigabit Ethernet links, and the switch SWA has the following interface configuration:
[SWA]interface GigabitEthernet 1/0/1
[SWA-GigabitEthernet1/0/1]gvrp
[SWA-GigabitEthernet1/0/1]port link-type trunk
[SWA-GigabitEthernet1/0/1]port trunk permit vlan 1 10
[SWA]interface GigabitEthernet 1/0/2
[SWA-GigabitEthernet1/0/2]port link-type trunk
[SWA-GigabitEthernet1/0/2]port trunk permit vlan 1 10
If you want to configure link aggregation to aggregate these two links together, if the configuration on the SWB is correct, you can know from the above information

A) Only when GigabitEthernet1/0/2 and Gigabit1/0/1 allow all VLANs to pass, they can join the same aggregation group
B) Only by changing the configuration of GigabitEthe1/0/2 to be consistent with GigabitEthe1/0/1, can they join the same aggregation group
C) After link aggregation is configured on both SWA and SWB, if both SWA and SWB enable MSTP on the aggregation port, GigabitEthernet1/0/1 and GigabitEthe1/0/2 can participate in forwarding
D) After link aggregation is configured on SWASWB, if both SWA and SWB enable MSTP on the aggregation port, one of GigabitEthe1/0/1 and GigabitEthe1/0/2 will be blocked

Solutions: