2021 JN0-362 dumps review - Professional Quiz Study Materials
JN0-362 Test Prep Training Practice Exam Questions Practice Tests
JN0-362 Exam topics
Candidates must know the topics before they start of preparation because it will really help them solving the problems. Our JN0-362 practice test and CAU-305 practice exams will include the following topics. These are covered in our JN0-362 dumps.
NEW QUESTION 15
Which two statements are true for GRE tunneling? (Choose two.)
- A. GRE tunnels support only one logical unit per interface
- B. GRE tunnel endpoints must have a valid route to the remote endpoint
- C. GRE tunnels support multiple logical units per interface
- D. GRE tunnels are stateful by default
Answer: B,C
NEW QUESTION 16
Click the Exhibit button.
Both configuration hierarchies shown in the exhibit have been committed to your MX Series device. Which two statements are true in this scenario? (Choose two.)
- A. Traffic destined to 10.3.0.1 will use the R1-to-R6 LSP as a next hop
- B. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 7
- C. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 5
- D. Traffic destined to 10.3.0.1 will not use the R1-to-R6 LSP as a next hop
Answer: A,B
NEW QUESTION 17
Click the Exhibit button. An interface is configured as shown in the exhibit.
What must also be configured for this interface to participate in VLAN 100 and 200?
- A. bridge domains
- B. broadcast domains
- C. encapsulation type
- D. VLANs
Answer: A
NEW QUESTION 18
Click the Exhibit button.
In the network shown in the exhibit, all switches are configured with the default STP root bridge priority, and Switch A has been selected as root. You recently added the older Switch D into the network as an access switch, and notice it has taken over as root.
Which configuration would solve this problem?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 19
Which statement about a virtual-router type of routing instance is correct?
- A. It is used to separate large networks into smaller administrative entities
- B. It is the only routing instance type supported on Junos devices
- C. It is used to create and maintain separate routing and forwarding tables
- D. It is used in Layer 3 VPN implementations
Answer: C
NEW QUESTION 20
Which two Layer 2 protocols are supported on MX Series devices? (Choose two.)
- A. BGP
- B. RIP
- C. RSTP
- D. MSTP
Answer: C,D
NEW QUESTION 21
Which statement is true when using VLANs in a bridge domain on an MX Series device?
- A. The VLAN tags of the received packet are always translated.
- B. Outer and inner VLAN tags always checked at egress.
- C. Only outer VLAN tags can be normalized.
- D. The VLAN tag of the received packet must match the VLAN tags associated with one of the logical interfaces.
Answer: D
NEW QUESTION 22
Click the Exhibit button.
You are troubleshooting a new BGP peering session which is not establishing.
Referring to the exhibit, which statement is true?
- A. The peer's AS number is misconfigured
- B. The neighbor does not support IPv6
- C. The update messages contain an unsupported option
- D. The TCP session is not establishing
Answer: A
NEW QUESTION 23
Which two statements describe operations performed by the encapsulating tunnel endpoint in an IP-IP tunnel? (Choose two.)
- A. It decrements the time-to-live (TTL) counter by one in the inner IP header
- B. It creates and adds a new inner IP header with the remote destination device's IP address
- C. It adds an outer IP header with the destination address of the remote tunnel endpoint
- D. It modifies the source and destination addresses in the inner IP header
Answer: A,C
Explanation:
Explanation/Reference:
NEW QUESTION 24
What is the purpose of STP BPDUs?
- A. to determine the root-alternate port
- B. to determine the root bridge
- C. to determine the least cost path
- D. to exchange MAC addresses
Answer: C
NEW QUESTION 25
Click the Exhibit button.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The OSPF neighbor will be declared down if 500 BFD hello packets are missed
- B. The OSPF neighbor will be declared down if BFD hello packets are not received for 1.5 seconds
- C. The OSPF neighbor will be declared down if BFD hello packets are not received for 5 seconds
- D. The OSPF neighbor will be declared down if three BFD hello packets are missed
Answer: B,D
Explanation:
Explanation
NEW QUESTION 26
Click the Exhibit.
Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1.
What is the appropriate prefix for the aggregate route in this scenario?
- A. 172.42.32.0/21
- B. 172.42.32.0/20
- C. 172.42.32.0/19
- D. 172.42.32.0/22
Answer: C
NEW QUESTION 27
What is the Junos default router priority advertisement value for IS-IS?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 28
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1
- B. Routes from 10.3.3.3 are less preferred than the default local preference
- C. Routes from 10.1.1.1 are less preferred than the default local preference
- D. Routes from 10.1.1.1 are less preferred than routes from 10.2.2.2
Answer: A
NEW QUESTION 29
Click the Exhibit button.
You are configuring an IBGP group. When you commit your configuration, you receive the error shown in the exhibit.
Which additional configuration parameter must you add to your configuration?
- A. export <policy name>
- B. type internal
- C. type external
- D. multipath
Answer: B
NEW QUESTION 30
You have two OSPF routers that are trying to form an adjacency. When you issue the command show ospf neighbor, you see that one router is in the loading state and the other is in the full state.Why are you seeing the router's state as loading?
- A. The router does not know about the received LSA header and has transmitted a link-state request.
- B. The router has established bidirectional communication with its peer.
- C. The router has finished transmitting, but is still receiving database information.
- D. The router is waiting for a start event.
Answer: C
NEW QUESTION 31
You have been asked to identify what the contributing routes are for route 204.7.15/21.Which command will show this information?
- A. show route 204.7.15/21 exact summary
- B. show route 204.7.15/21 detail
- C. show route 204.7.15/21
- D. show route 204.7.15/21 extended
Answer: B
NEW QUESTION 32
......
How to study the JN0-362 Exam
A solid foundation on Multiprotocol Label Switching (MPLS) is required. After beginner concepts such as MPLS forwarding and the structure of the MPLS header, you should learn into the configuration and operation of the two main label distribution protocols, RSVP and LDP. Give special emphasis to the central topics of traffic engineering and MPLS traffic protection, including fast reroute, link/node protection, and LDP loop-free alternate. Put into practice with a series of in-depth hands-on labs, which will allow candidate to gain experience in configuring and monitoring MPLS on Junos OS devices. Utilize Juniper Networks vMX Series devices using the Junos OS Release 16.1R3.10, but are also applicable to other MX Series devices.JN0-362 practice exams provides detailed resources and items on the JN0-362 exam. The JN0-362 dumps will help you identify the content and difficulty level of the questions and the practice Exams will make you familiar with the format and environment of an exam. You should refer this JN0-362 dumps carefully before attempting your actual exam.
Exam Facts
The Juniper JN0-362 exam brings a total of 65 questions in multiple-choice form. Its duration is 90 minutes and candidates can register for this test through Pearson VUE and take it on the same website. However, there’s no specific way to determine the test results. So, candidates will be graded based on the results they score on a Pass/Fail basis. Juniper reveals the test results immediately after completing the exam and they always recommend solid mastery of the Junos Software Release 19.4 before attempting this test.
Exam Questions Answers Braindumps JN0-362 Exam Dumps PDF Questions: https://www.practicedump.com/JN0-362_actualtests.html