Mar-2022 Realistic 500-220 Exam Dumps with Accurate & Updated Questions
500-220 Exam Dumps - PDF Questions and Testing Engine
NEW QUESTION 31
Refer to the exhibit.
Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?
- A. WebEx traffic will prefer WAN 2 as long as it is up.
- B. WebEx traffic will prefer WAN 1 as it is the primary uplink.
- C. WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the "Conf" performance class.
- D. WebEx traffic will be load-balanced between both active WAN links.
Answer: B
NEW QUESTION 32
Refer to the exhibit.
Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)
- A. Set the speed of the cellular uplink to zero.
- B. Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.
- C. Change the primary uplink to "none".
- D. Add an internet traffic preference that defines the load-balancing ratio as 4:1.
- E. Enable load balancing.
Answer: D,E
NEW QUESTION 33
Drag and drop the settings from the left into the boxes on the right to indicate if the setting will be cloned or not cloned using the Cisco Meraki MS switch cloning feature.
Answer:
Explanation:
NEW QUESTION 34
A new application needs to be pushed to all iOS devices. Some devices report "NotNow" in the event log and do not install the application.
What does the "NotNow" event indicate?
- A. The device is locked with a passcode.
- B. The device cannot connect to Apple servers.
- C. The device cannot connect to Cisco Meraki servers.
- D. The application requires the most recent iOS version.
Answer: A
NEW QUESTION 35
Where should a network admin navigate to investigate wireless mesh information between Meraki APs?
- A. Wireless > Monitor > RF Spectrum
- B. Wireless > Monitor > Wireless Health
- C. Wireless > Configure > Radio Settings
- D. Wireless > Monitor > Access Points > AP > RF
Answer: D
NEW QUESTION 36
A Cisco Meraki MV camera is monitoring an office and its field of vision currently captures work desks and employee computer screens. However, recording employee computer screens is prohibited by local regulation.
Which feature in Dashboard can be used to preserve the current position of the camera while also meeting regulation requirements?
- A. privacy window
- B. sensor crop
- C. area or interest
- D. zone exclusion
- E. restricted mode
Answer: E
NEW QUESTION 37
Company iPads are enrolled in Systems Manager without supervision, and profiles are pushed through Systems Manager.
Which outcome occurs when a user attempts to remove the "Meraki Management" profile on an iPad?
- A. The "Meraki Management" profile cannot be removed.
- B. The "Meraki Management" profile is removed. All the profiles that Systems Manager pushed are also removed.
- C. The "Meraki Management" profile is removed and then pushed automatically by Systems Manager.
- D. The "Meraki Management" profile is removed. All the profiles Systems Manager pushed remain.
Answer: B
NEW QUESTION 38
Which configuration step is necessary when automatic updating is required of iOS apps provisioned through Systems Manager that are found in the App Store?
- A. Configure automatic updating of iOS devices in the Meraki installed profile.
- B. Create a profile with automatic update enabled and apply it to iOS devices.
- C. Create a security policy that enables automatic updates.
- D. No configuration step is necessary; automatic updating is the default behavior.
Answer: C
NEW QUESTION 39
Refer to the exhibit.
For an AP that displays this alert, which network access control method must be in use?
- A. MAC-based access control with RADIUS server
- B. preshared key
- C. WPA2-enterprise with my RADIUS server
- D. splash page with my RADIUS server
Answer: B
NEW QUESTION 40
Which type of authentication protocol is used when using OSPF on an MX appliance?
- A. certificate
- B. plaintext
- C. SHA-1
- D. MD5
Answer: D
Explanation:
Reference:
Using_OSPF_to_Advertise_Remote_VPN_Subnets
NEW QUESTION 41
Drag and drop the descriptions from the left onto the corresponding MX operation mode on the right.
Answer:
Explanation:
NEW QUESTION 42
Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?
- A. starts on both MX appliances at the same time and then immediately reboots both appliances
- B. starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases
- C. starts on the secondary MX appliance and then occurs on the primary MX appliance
- D. starts on the primary MX appliance and then occurs on the secondary MX appliance
Answer: D
NEW QUESTION 43
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs AMP for inter-VLAN traffic.
- B. The MX appliance performs content filtering for inter-VLAN traffic.
- C. The MX appliance performs IDS/IPS for inter-VLAN traffic.
- D. The MX appliance performs data encryption for inter-VLAN traffic.
Answer: D
NEW QUESTION 44
Which information is used to calculate whether a WAN link has high usage?
- A. total number of devices that are actively passing traffic
- B. data under Security & SD WAN > Appliance Status > Uplink > Live Data
- C. total historical throughput of an uplink
- D. value under Security & SD WAN > SD WAN & Traffic Shaping > Uplink Configuration
Answer: D
NEW QUESTION 45
Which design requirement is met by implementing syslog versus SNMP?
- A. when organization-wide information must be collected
- B. when proactive alerts for critical events must be generated
- C. when information such as flows and client connectivity must be gathered
- D. when automation capabilities are needed
Answer: C
Explanation:
Reference:
Meraki_Device_Reporting_-_Syslog%2C_SNMP%2C_and_API
NEW QUESTION 46
Which two Systems Manager Live tools are available only for Apple Macs and Windows PCs and cannot be used on iOS or Android mobile devices? (Choose two.)
- A. Send notification
- B. Selective wipe
- C. Screenshot
- D. Remote Desktop
- E. OS updates
Answer: B,D
NEW QUESTION 47
What is the best practice Systems Manager enrollment method when deploying corporate-owned iOS devices?
- A. manual
- B. Sentry enrollment
- C. Apple Configurator
- D. DEP
Answer: C
NEW QUESTION 48
Refer to the exhibit.
Which IDS/IPS mode is the MX Security Appliance configured for?
- A. quarantine
- B. detection
- C. blocking
- D. prevention
Answer: D
NEW QUESTION 49
How does a Meraki device behave if cloud connectivity is temporarily lost?
- A. The offline device stops passing traffic.
- B. The offline device tries to form a connection with a local backup sever.
- C. The offline device continues to run with its last known configuration until cloud connectivity is restored.
- D. The offline device reboots every 5 minutes until connection is restored.
Answer: B
NEW QUESTION 50
What happens to an unsupervised iOS device when the "Meraki management" profile is removed?
- A. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed are also removed.
- B. The "Meraki management" profile cannot be removed.
- C. The "Meraki management" profile is removed. All configuration profiles that Systems Manager pushed remain.
- D. The "Meraki management" profile is removed and then pushed automatically by Systems Manager.
Answer: A
NEW QUESTION 51
Refer to the exhibit.
What are the Loss and Average Latency statistics based on?
- A. responses that the MX appliance receives on the connectivity-testing IP addresses on the Security & SD- WAN > Firewall page
- B. responses that the MX appliance receives on the connectivity-testing IP addresses on the Help > Firewall info page
- C. responses that the MX appliance receives on the connectivity-testing hostnames on the Insight > Web App Health page
- D. responses that the MX appliance receives on the connectivity-testing IP address that is configured on the Security & SD-WAN > SD-WAN & Traffic Shaping page
Answer: A
NEW QUESTION 52
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Jitter
- B. Application Response Time
- C. Maximum Latency
- D. Per-flow Goodput
- E. Total Bandwidth Usage
Answer: B,D
NEW QUESTION 53
......
Cisco 500-220 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
Pass Cisco 500-220 Exam Quickly With PracticeDump: https://www.practicedump.com/500-220_actualtests.html
500-220 Dumps - The Sure Way To Pass Exam: https://drive.google.com/open?id=1MAofnzO7nclQBHtbeW6UO-999Rt7RwDq