[Sep 28, 2021] Updates Up to 365 days On Valid NSE7_SDW-6.4 Braindumps
Best QualityNSE7_SDW-6.4 Exam Questions Fortinet Test To Gain Brilliante Result
NEW QUESTION 21
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Explanation/Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 22
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: A
NEW QUESTION 23
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify incoming interfaces in SD-WAN rules.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify outgoing interface routing cost.
Answer: B,D
NEW QUESTION 24
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
NEW QUESTION 25
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: A
NEW QUESTION 26
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- B. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- C. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- D. The dead member interface stays unavailable until an administrator manually brings the interface back.
Answer: A
NEW QUESTION 27
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link member.
- B. diagnose sys virtual-wan-link neighbor.
- C. diagnose sys virtual-wan-link service
- D. diagnose sys virtual-wan-link route-tag-list
Answer: A
NEW QUESTION 28
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. FortiGate provides statistics and readings based on historical traffic logs.
- B. This traffic shaper drops traffic that exceeds the set limits.
- C. Traffic being controlled by the traffic shaper is under 1 Kbps
- D. The debug output shows per-lP shaper values and real-time readings.
Answer: A,D
NEW QUESTION 29
Which statement reflects how BGP tags work with SD-WAN rules?
- A. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- D. BGP tags match the SD-WAN rule based on the order that these rules were installed.
Answer: B
NEW QUESTION 30
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Internet service database (ISDB) address object
- B. Application signatures
- C. URL categories
- D. Source and destination IP address
- E. Type of physical link connection
Answer: A,C,D
NEW QUESTION 31
Which statement about using BGP routes in SD-WAN is true?
- A. Adding static routes must be enabled on all ADVPN interfaces.
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Dynamic routing protocols can be used only with non-encrypted traffic
- D. VPN topologies must be form using only BGP dynamic routing with SD-WAN
Answer: B
NEW QUESTION 32
Refer to exhibits.
Exhibit A.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: D
NEW QUESTION 33
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
Answer: A,B
NEW QUESTION 34
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 35
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients
- B. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
- C. VPN static routes are prevented from populating the FortiGate routing table
- D. There are separate virtual interfaces for each dial-up client
Answer: D
NEW QUESTION 36
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC transmits additional packets as redundant data to the remote device.
- C. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- D. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
- E. FEC transmits the original payload in full to recover the error in transmission.
Answer: B,C
NEW QUESTION 37
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 38
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices
- B. It improves SD-WAN performance on the managed FortiGate devices.
- C. It acts as a policy compliance entity to review all managed FortiGate devices
- D. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server
- E. It sends probe signals as health checks to the beacon servers on behalf of FortiGate
Answer: A,D
NEW QUESTION 39
Which statement about using BGP routes in SD-WAN is true?
- A. Learned routes can be used as dynamic destinations in SD-WAN rules.
- B. Dynamic routing protocols can be used only with non-encrypted traffic.
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. VPN topologies must be form using only BGP dynamic routing with SD-WAN.
Answer: A
Explanation:
Explanation/Reference:
https://www.fortinetguru.com/2019/09/using-bgp-tags-with-sd-wan-rules-fortios-6-2/#:~:text=SD%2DWAN%
20rules%20can%20use,to%20the%20customer's%20data%20center.
NEW QUESTION 40
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead because no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: B
NEW QUESTION 41
......
Focus on NSE7_SDW-6.4 All-in-One Exam Guide For Quick Preparation: https://www.practicedump.com/NSE7_SDW-6.4_actualtests.html
Tested Material Used To NSE7_SDW-6.4: https://drive.google.com/open?id=1QcYT_tI6xe2WttKfU8Rf_gJK7gV2RAJv